Thursday, January 17, 2019
1 800 317 9054

 Solar Pool Heater Sizing

Proper sizing a solar pool heater is important to ensure you get the results you are looking for when investing in a solar pool heater. There are many variables that play an important part of a pool's heat loss requirements. In most pools 80-90% of the heat is lost through the surface of the pool. In ground pools are more insulated on the sides than above ground pools and the earth acts as a natural insulator. Because of the surface heat loss we always recommend the first investment should be a solar pool cover. Investing in a solar heater without a cover on the pool is like trying to heat a house when all the windows are open.
Wind speed and shading also play an important role in determining how much heat is lots from a pool. The windier the location the more heat will be stripped from the pools surface. Again a great reason to add a solar cover.

Solar insolation map The outdoor temperature and season of use are also very important in determining if a solar pool heater will meet your expectations. If you are trying to heat an outdoor pool in Minnesota, you may extend your season to May- September. However in southern USA, a solar pool heater may allow you to comfortably enjoy your pool year round. Using a solar insolation map will be helpful in determining how much annual sun you can harness with your solar pool heater.

In some cases to meet your temperature objectives you may consider going with both a solar pool heater as well as a backup natural gas or propane pool heater. In this way you can rapidly bring up the water temperature in the spring and then allow your solar water heater with solar cover to maintain the temperature with little need for the gas pool heater.

Solar Vacuum Tube Pool Heaters will deliver substantially more heat to pools in colder climates. However in warm climates where pool temperatures exceed 90 F in the summer, the solar pool heating system may need to be covered up to avoid over heating the pool!
When calculating the number of vacuum tube collectors that are needed for a pool you can use the chart below as a general rule of thumb. However as mentioned many variable will play in determining how much energy is going into the pool versus how much is leaving. Only when there is a surplus of energy will the pool temperature rise.

Solar Pool Heating System Sizing*

Surface Area


100-200 ft2

200-300 ft2

300-400 ft2

400-500 ft2

SPH-1  X        
SPH-2    X      
SPH-3      X    
SPH-4        X  
SPH-5          X

 *NOTE Pools larger than this should use multiple pool heaters a 1000ft2 pool should use 2 x SPH-5 systems in parallel. Sizes are approximate, geographical location and the use of a pool cover will effect sizing.

Free Solar Heating Simulations

Free Solar Heating Simulations

Click here to get a  FREE Solar Heating Simulation  

Request More Information

Email *
Zip Code: *
Solar Pool Heating
Solar Hot Tub Heating
Domestic Solar Water Heat
Solar Space Heat for home or shop
Commercial Solar Heating Project
Solar PV Systems (electrical)


In The News

Northern Lights Solar Solutions (NLSS) has completed a partnership deal with Canadian based Latitude 51 Solar. This partnership will allow Latitude 51 to continue its Canadian distribution of the Northern Lights Solar Thermal products. The ...


123ZeroEnergy in conjunction with Northern Lights Solar Solutions supplies the Enmax conservatory located in Calgary, AB Canada with 16 high performance solar vacuum tube collectors. The Sun Rain solar evacuated tubes are consider ...

From Kevin M. - Port Egin Ontario, solar swimming pool heating


This article is describing a large outdoor solar heated swimming pool.  As you can read from this story a single 30 tube solar collectors is helping maintain the pools ...

Good afternoon,
Our very simple solar water system has been up and running since the end of
March. Even on cloudy days it provides more than enough hot water for our
needs. We had no previous experience with solar water heating, so put this
together in ...

 Terry Fenwick, Harwood, Ontario
I installed my two 30 tube collector system in late November 2010.

My design goal was to maximize the winter heat gain to help heat water used for radiant floors and my domestic hot water. I have started ...

Stuart L - Near Ottawa
I've attached some photos. One is of 2 Latitude51 panels in a neighbour's system. The others are of my system. My heat/hot water system includes a wood boiler and 600 gallon heat storage tank shown in one photo. The tank has ...

I purchased a system last fall from Latitude51 Solar, originally thought I would need a 60 tube setup
but have found the 30 tube works just fine for me and my wife even though we have a tree shading
problem around our yard.
I have an on demand ...

 From Mike Holden, Ontario
System: 2 x 30 tube collectors, custom install for DHW and space heating.
"The great thing about solar energy, is that it is "free", the downside of solar energy, is that YOU must make a commitment, both ...

From George Skeet - High River Alberta.
System: 2 x 30 tube collectors, 2 x 70 gallon tanks.
Just a quick note to show we did put the panels we bought from you to work. To date the controller says we have produced 2200 kwh of energy. The controller ...

From Wayne Larsen - Big Bar Lake, BC
System: 4 x 30 evacuated tube solar collectors, The owner built his own house incorporating energy efficient designs and right from the beginning the plan was to incorportate solar hot water space heating into the ...

 From Doug S. - SE Calgary
System: 3 x 30 tube collectors, 80 Gallon Tank
For the last 3 and a half weeks (May 2011) we have had the panels run the tank up to 75 C but usually average 50-60 Deg C- range.

One of the reasons for this we have ...

Popular Items